描述：4BE4” LED ModuleFEATURES & SPECIFICATIONSINTENDED USE — Our recessed LED module is the most economical means to create a well lit environment with exceptional energy efficiency and near zero maintenance. Great for retrofit into existing downlight cans or new construction and remodel applications. Compliant friction clip retention allows fitment into nearly 100% of installed cans. The LED module maintains at least 70% light output for 35,000 hours. Indoor and Outdoor Use.CONSTRUCTION — Aluminum spun reflector with deep baffle configuration for reduced glare. Combined LED and driver printed circuit board attached. Inner reflector cone funnels light through the pressed-in diffused lens.OPTICS — Diffused lens at end of mixing chamber to provide even light distribution for general illumination, equivalent to 65W BR30 Lamp.Wide flood beam angle at > 45°.ELECTRICAL — Center 2 Edge? (patent pending) technology created for a single point source. Primary power disconnect provided for simple connection to a dedicated LED connector in the housing.Dimming down to 10%. For compatible dimmers, refer to Compatible Dimmers Chart.700-lumen E series has an input wattage of 10 watts, 70 lumens per watt, equivalent to 65-watt incandescent.E Series' patent pending driver has zero inrush which allows power loads to be calculated with actual rated wattages.Example: 60 units of 4BEMW LED fixtures can be installed in line with a 600-watt dimmer. 600W/10W = 60 fixtures.INSTALLATION — Suitable for installation in standard height rough-in sections.E26 socket adapter and ships standard.Friction clips allow fitment into cans with an inside diameter of 4.0” to 4.5".LISTINGS — CSA certified to US and Canadian safety standards. ENERGY STAR? certified. Can be used to comply with California Title 24 Part6 High Efficacy LED Light Source Requirements. Wet location listed. WSEC ASTM E283 for Air-Tight (with IC housings).WARRANTY — 5-year limited warranty.Note: Actual performance may differ as a result of end-user environment and application.All values are design or typical values, measured under laboratory conditions at 25 °C.Specifications subject to change without notice.PATENTS PENDING.